Training courses and support sessions

Hi all,

we are looking at starting training sessions to all those who are struglling and/or would like to find out more about the 3D printing – like practical advices, tips and tricks, 3D printer maintenance, repairs and similar topics

At this stage we are looking at potential topics and even expression of interest.

If you would be interested to attend and/or have question/suggestion that you would like to be address send us an email to – that would help us a lot.

See you soon

PlaPlus – high temp PLA that withstands up to 100C temp

Hi all,

finally we have added High Temp resistant PLA to our range.

At normal conditions it is slightly softer than our standard range, it doesn’t snap, glass transition temp is few degrees lower than standard PLA. To Achieve high temp resistance the prints have to be temperature treated. all it takes is 30minutes @ 80C. The cup in the picture was annealed in about 2 minutes by pouring boiling water into it.

The range of colours at this stage will be limited. The filament is not glossy like standard PLA – it is like velvet. THe price is only couple $ more than standard PLA – $35.95/kg spool