PlaPlus – high temp PLA that withstands up to 100C temp

Hi all,

finally we have added High Temp resistant PLA to our range.

At normal conditions it is slightly softer than our standard range, it doesn’t snap, glass transition temp is few degrees lower than standard PLA. To Achieve high temp resistance the prints have to be temperature treated. all it takes is 30minutes @ 80C. The cup in the picture was annealed in about 2 minutes by pouring boiling water into it.

The range of colours at this stage will be limited. The filament is not glossy like standard PLA – it is like velvet. THe price is only couple $ more than standard PLA – $35.95/kg spool

http://www.aurarum.com.au/38-high-temp-filament

 

Leave a Reply

Your email address will not be published. Required fields are marked *